Dtape Dt50 User Manual Pdf To Use Work Guide

Powers on the device and triggers the laser to take measurements.

The DT50 supports multiple unit formats including meters (m), feet (ft), inches (in), and fractional feet/inches (0'00" 1/16).

By default, the device measures from its rear edge. This can be adjusted to measure from the front edge to suit different project needs. Advanced Measurement Modes dtape dt50 user manual pdf to use work

Press the button once to add ( + ) or twice to subtract ( - ). Take your second measurement.

Avoid measuring directly into bright sunlight; shade the target area. Best Practices for Maintenance Powers on the device and triggers the laser

Press the button until the rectangle icon appears on the screen. Press MEASURE to capture the length. Aim and press MEASURE to capture the width.

I recently picked up the D-TAPE DT50 to replace my old, battered manual tape measure, specifically for solo woodworking projects. After spending a few weeks with it, here is my breakdown of how it performs in actual work scenarios. This can be adjusted to measure from the

Stand stationary and aim at the highest point (Hypotenuse). Press .

Essential for HVAC sizing, concrete pours, and environmental insulation planning. Press the button until the cube icon appears. Measure the Length , then the Width , and finally the Height .

Press the +/– button when no active measurement is taking place to scroll backward through your saved records.

The minimum distance recorded during the sweep (middle line). Main Line: The current real-time distance.