Hw 130 Motor Control Shield For Arduino Datasheet Better Fixed

The shield stacks directly on an , Mega 2560 (partial pin usage), or Nano (with careful alignment). Below is the critical mapping:

The HW-130 Motor Control Shield is widely available from a variety of online retailers, including Amazon, eBay, and AliExpress. It is also available from specialty electronics stores and Arduino distributors.

The HW-130 is a dual H-bridge motor driver shield based on the STMicroelectronics chip. It is designed to drive two DC motors or one stepper motor. Unlike the standard raw L298N modules, this shield is form-fitted to plug directly onto an Arduino Uno or Mega, eliminating messy wiring. hw 130 motor control shield for arduino datasheet better

// Motor B backward digitalWrite(IN3, LOW); digitalWrite(IN4, HIGH);

Powering this shield correctly is the most common hurdle for new users: The shield stacks directly on an , Mega

2 × 5V servo connections (powered by Arduino 5V). Voltage Range (Motors): 4.5V VDC to 25V VDC.

A: No. It is a clone of Adafruit Motor Shield V1 and is only compatible with the Adafruit Motor Shield V1 Library . The HW-130 is a dual H-bridge motor driver

Screw terminal for external battery (4.5V - 25V) to power motors.