Kes Geyser Load Control Timer Manual New ((install)) -

The base of the KES load control timer features numbered terminal blocks. While layout designs can vary slightly across new production batches, the standard high-capacity terminal sequence operates as follows:

Clears all saved settings and internal memory. Access with a paperclip or pin. 3. Initial Setup and Setting the Clock

Always turn off the main power and geyser isolator before attempting installation.

If the current time falls inside an active schedule when you switch to AUTO, toggle the mode to ON first, then switch it to AUTO . If the current time is outside a schedule, toggle to OFF first, then switch to AUTO . Troubleshooting Common Issues The Screen is Completely Blank kes geyser load control timer manual new

While still holding the Clock button, press to adjust the current hour (uses a 24-hour clock format).

Connect the Neutral (Black) wire from the DB neutral bar to the N terminal.

Adjusts the minutes for both the system clock and programs. The base of the KES load control timer

For detailed technical diagrams and full program options, refer to the HellermannTyton Geyser Timer Manual .

Connect to the main Neutral bar or incoming Neutral wire.

The LED will flash to indicate the current selection (e.g., LED 1 flashing means Program 1). If the current time is outside a schedule,

The new KES models come with three preset programs. You can cycle through these by holding the Prog 1 (1 Flash):

Simple, right? Wrong.

Despite being a reliable device, users can sometimes encounter issues. These problems, and their potential fixes, have been shared by owners in community forums like MyBroadband and Fixya.

Cycles through the 16 available ON and OFF program slots.