For the full detailed documentation, you can access the Life Probo PR70 Manual PDF or view the official guide on ManualsLib .
The release cord should be positioned at a height that is accessible but does not interfere with vehicle or foot traffic, typically no higher than 1.8 meters.
: Under applicable European and international statutes, installation may only be performed by certified, professional fitters.
Verify the operator's drive carriage is fully re-engaged with the track belt/chain. For the full detailed documentation, you can access
integrated into the motor cover for garage illumination. Section 4: Mechanical Assembly and Rail Setup Rail Assembly Lay rail segments flat on a clean, level floor surface.
Route low-voltage signaling lines (e.g., photo-eye sensors, wall push-buttons, flashing warning lights) through the dedicated entry knockouts.
any components not specified in this official manual. Technical Data Power Supply : 230V AC (50-60Hz) Motor Voltage : 24V DC Max Thrust : 700N Gate Surface Area : Up to 10 square meters Opening Speed : 8 meters per minute Section 2: Pre-Installation Checklist and Tools Required Tools Electric drill with concrete and metal masonry bits. Verify the operator's drive carriage is fully re-engaged
The system must be installed in compliance with current local regulations and safety standards. Disconnect power before making any electrical connections.
Before drilling or assembling the components, verify that the structural parameters of your garage door match the operational limits of the : Door Surface Area : Up to 9 square meters. Max Pull/Push Force : 700 N (Newton).
Use the emergency release cord during power outages. Route low-voltage signaling lines (e
through the dedicated cable strain relief entries. Connect live wire to terminal marked "L" on the board. Connect neutral wire to terminal marked "N" on the board. Ground the system by wiring directly to the earth terminal. Accessory Integration
: The system uses grease for lubrication; regular inspection of the rail and moving parts is recommended Peiter Automatic Safety Warnings