The SATLINK WS-6906 is a 3.5-inch digital satellite finder that allows users to view live FTA channels and calibrate dishes. It supports DiSEqC 1.0 and operates within a frequency range of 950MHz to 2150MHz. Over time, manufacturers release software updates primarily to improve device sensitivity, add support for new transmission standards like TPS, or fix software bugs.
Turn the power switch on the Satlink WS-6906 meter immediately after clicking start.
Satellite frequencies, symbols rates, and transponder data change frequently. Updating your device ensures optimal performance. satlink ws-6906 software upgrade
Launch the Satlink upgrade software on your computer. Set the protocol configuration exactly as follows: Match your assigned COM port (from Step 1). Bits per second (Baud Rate): 115200. Data bits: 8. Parity: None. Stop bits: 1. 4. Load the Firmware File
: Place the .bin update file in the root directory (not inside a folder). The SATLINK WS-6906 is a 3
Set the to 115200 (standard for this device).
: When the program prompts to "Check Serial Port Status," turn the WS-6906 off for 10 seconds and then turn it back on . The updater should now detect the device and start writing data. Turn the power switch on the Satlink WS-6906
Plug the reverse end (RS-232 or USB converter) into an active port on your desktop or laptop motherboard.
Ensure the battery is charged to at least 70%.
: The official Satlink upgrade tool executable (usually Upgrade.exe or STB_Editor ). 💾 Step 1: Downloading the Correct Software and Drivers Find the Firmware
Drivers for your USB-to-RS232 adapter (e.g., Prolific or CH340). Step-by-Step Firmware Upgrade Process