Navigate to the project directory, which acts as the control center for building image files: cd ~/sigmastar_devkit/project Use code with caution.
Or for low-memory versions, you may use a configuration with an lr suffix.
Ensure you did not skip the apt-get installation step in Section 1. Double check that libssl-dev and lzma are present. 2. File Not Found During Cross-Compilation sigmastar sdk install
make clean make all 2>&1 | tee build.log
./setup_config.sh configs/ipc/i6b0/nor.uclibc-squashfs.009b.128.qfn128 Navigate to the project directory, which acts as
If your project utilizes SigmaStar's Deep Learning Accelerator (DLA), you will also need to set up a Python virtual environment with the required dependencies. The DLA SDK's conversion and simulation tools rely on specific Python packages.
Before installing the SDK, you must prepare a Linux development environment. A system is highly recommended. 1.1. Install Essential Libraries Double check that libssl-dev and lzma are present
Power on the board and press any key to stop the automatic boot and enter the [root@SSD20X #] prompt. Run the update command: usb_upg Use code with caution. After the upgrade is complete, run: reset Use code with caution. 5. Troubleshooting Common Installation Issues
Upon successful completion, your output artifacts—bootloader, kernel, and root filesystem images—will typically be found in a directory like image/output/images/ .