Two wireless remote controls and the armrest joystick. 3. Rail Assembly and Installation
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
: Measure the staircase and cut the aluminum rail to the required length .
Verify that the safety edges on the footrest and drive unit stop the lift immediately upon contact with an obstacle. thyssenkrupp levant stair lift installation manual full
Run the low-voltage charging wires from the bottom strip along the internal channel of the rail up to the top strip, or vice versa.
Slide the second rail section over the alignment bars until the two ends meet flush.
Push the rail assembly against the wall or baseboard, then pull it out approximately 1.5 to 2 inches (40-50 mm) to allow clearance for the seat back. Step 3.3: Anchoring the Rail Two wireless remote controls and the armrest joystick
: Verify the 4.5-inch minimum rail-to-wall clearance.
Use the armrest joystick to drive the lift up and down the track.
Complete metric Allen key set (3mm to 8mm), metric socket set (10mm to 17mm), and an adjustable torque wrench. This link or copies made by others cannot be deleted
This comprehensive manual provides the technical steps, safety protocols, and adjustment procedures required to install the ThyssenKrupp Levant straight stair lift. Pre-Installation Preparation and Tools
Fasten the rail securely to the stair steps. If installing on carpet, screws must penetrate through to the wood or concrete beneath. 3. Drive Unit and Electrical Setup