| Symptom | Possible Cause | Solution | |:--------|:---------------|:---------| | No power / LEDs off | Power supply issue | Verify DC 12V and polarity | | Reader doesn't read cards | Card type mismatch | Ensure EM 125kHz card compatibility | | Buzzer continuously beeps | Anti-tamper triggered | Check cover is properly secured | | Access denied despite valid card | Access mode mismatch | Check if system requires Card+PIN | | Memory full when adding card | User capacity reached (1000 users) | Delete unused users before adding |
While in programming mode, press then "0" then "2" .
The V2000-C RFID Access Control system is a standalone device supporting up to 2,000 users with card-only, PIN-only, or combined verification modes for single-door security. It features a stainless steel design, 12V DC power requirements, and supports Wiegand 26-bit interfacing for integration. Detailed instructions for installation and user enrollment can be found in the savebase.com manual www.goldbridgesz.com V2000-c Rfid Access Control User Manual
Power must cut off to unlock. Connect the lock to NC and COM .
Wiegand 26 bits input & output (can operate as an external reader) LED Indicator & Audio Reference Normal Mode: Red LED is lit. Programming Mode: Green LED is lit or flashing. Valid Action: Short beep sounds. Invalid Action: Long, sustained error beep sounds. 2. Wiring Diagram and Installation | Symptom | Possible Cause | Solution |
Are you looking for a reliable and efficient access control solution for your organization? Look no further than the V2000-C RFID Access Control System. This user manual provides a detailed guide on how to install, configure, and operate the V2000-C system, ensuring that you get the most out of your access control investment.
: If you lose the system password, perform the initialization procedure to restore it to 12345 . Programming Mode: Green LED is lit or flashing
⚠️ Perform a factory reset if default master code does not work (usually by shorting a reset jumper or powering on while pressing # ).
NC (Normally Closed – for Fail-Safe/Magnetic locks) Grey: BELL (Doorbell connection) 3. Programming Guide
Egress input loop. Connect to a standard Exit Button.